Cable school training courses in Austin, TX (public, in-house or online)

When you complete this lesson, you will be able to identify the components of medium voltage cable and why each is needed.

Relate the difference in “pressure�between low voltage and medium voltage.
Describe corona.
Describe partial discharge.
Describe conductor stranding.
Identify the strand shielding
Describe conductor insulation.
Describe insulation stranding.

When you complete this lesson, you will be able to determine how to place your wire and cable in the conduit and cable tray.

Describe the use of the following:
Cable trays
Junction boxes
Wire ducts
Explain the importance of using a marking and numbering system.

This course is designed to provide a high level explanation of how cable TV and direct broadcast satellite TV work, and the architectures commonly used to distribute programming to the TV. The course describes the architecture and services offered by modern cable TV hybrid fiber/coax architectures, modern Broadband Passive Optical Network Fiber to the Premises (BPON) architecture being installed by Verizon communications, and architecture and services offered by modern Direct Broadcast Satellite...

Full archival course description>>

This Advanced Cable Router Course follows the current Introduction to Cisco® Cable Router ILT Course and addresses the needs of Cable Operator personnel with more than six months of on-the-job experience. The ACCR course will focus on understanding advanced design considerations, traffic flow characteristics, IOS-based security options and the effects of various tuning parameters available in the Cisco® IOS® software designed for Cable Modem Termination System (CMTS) products.
Students will l...

Full archival course description>>

The primary objective of this course is to teach students the recommended workflows and basic skills needed to design and document 3D electrical parts wire harness designs using Autodesk Inventor Professional.

Who Should Attend
This course is designed for experienced Autodesk Inventor users.

Prerequisites
Before taking this course, students should have a working knowledge of the following:

Autodesk Inventor parametric part and assembly design.
Mechanical design val...

Full archival course description>>